3. Repair Lights That Often Go Off
a. Check the Light Connection
- Turn off the power to the light by turning off the switch and MCB on the electrical panel.
- Remove the bulb from its place, then check for loose connections or any damage to the light holder.
- If the holder appears to be bent, use a small tool such as a flathead screwdriver to carefully straighten the contacts.
b. Clean the Light Contacts Carefully
- Make sure the power is off.
- Use fine sandpaper to clean the light holder contacts from rust or debris that interferes with the flow of electricity.
- Wipe the contact with a clean cloth to remove any dust or debris.
c. Replace the Lights with LED or CFL Type for Efficiency
- Choose a quality LED or CFL light according to the maximum wattage recommended for your lamp.
- LED lights are more durable and energy-efficient, while CFLs are suitable for less frequent use.
- Avoid low-quality lights that can cause problems such as quick shut-off or flickering.
4. Dealing with Interference in Electronic Devices
a. Find the Tool That Causes the Short Circuit
- If the power goes off frequently when a particular appliance is switched on, unplug the appliance and try to turn it on again.
- Connect the tools one at a time to find out which one is causing the short circuit.
- Problematic tools must be checked or repaired by a technician.
b. Tips for Caring for Tools to Make Them Durable and Safe
- Use electronic devices as directed, including the allowable wattage limit.
- Do not plug high-power tools into the power strip, as this may cause overheating or short-circuiting.
- Check the cable regularly to make sure it is in good condition.
8 Ways to Improve Electrical Safety at Home
Improving electrical safety in the home is essential to protect families and property from fire hazards and electrical accidents. Here are eight effective ways to improve electrical safety in your home:
1. Avoid Using Power Strips for High-Power Devices
Using power strips for devices that require a lot of power such as heaters, irons, and ovens can cause overloads that risk fire. It is recommended to connect the device directly to the appropriate wall socket.
2. Check Cables and Sockets Regularly
Performing periodic inspections of cables and sockets is essential to find damage such as cracks or chipped wires. If you find a damaged cable, replace it immediately to avoid a short circuit.
3. Don’t Run Power Cables Under Carpets
Running the power cord under the carpet may cause the cord to overheat and increase the risk of fire. It’s best to lay cables along walls or use cable channels to keep them safe and visible.
4. Keep Cables and Devices Dry
Moisture can cause a short circuit and damage electrical equipment. Make sure all electrical cables and devices are protected from water. If there is a leak, fix it immediately to prevent further problems.
5. Use Electrical Protective Equipment
Install a GFCI (Ground Fault Circuit Interrupter) in humid areas such as bathrooms and kitchens to protect against electric shock. The GFCI will cut off the power supply if a current imbalance is detected.
6. Ensure Good Ventilation
Make sure the electrical appliance is adequately ventilated so that it does not overheat. Avoid placing the device in an enclosed place or too close to other heat sources.
7. Turn off the device when not in use
Turn off all electrical devices that are not in use, especially those that use high power because they can cause heat. This will save energy and reduce the risk of fire.
8. Replacing Old Cables
If your home has old wiring or a substandard electrical system, consider replacing it with a safer system. Contact a professional electrician to check and update if necessary.
Before repairing the electricity, turn off the power in the main panel to avoid shock. Use the right tools and make sure the work area is dry. If you don’t understand, call an experienced technician. Always use protection such as insulating gloves and rubber shoes. If there is serious damage, such as sparks or burning odors, stop work and contact a professional. Your safety is paramount!